Water filter in-line granular activated carbon OMNIPURE K2533, 2 X 10″

Name: Water filter in-line granular activated carbon Omnipure
Availability: InStock

Water filter OMNIPURE K2533 In-line filter with granular activated carbon 2" x 10"

The water filter Omnipure K2533 is an in-line filter using granular activated carbon and part of the K-Series, built on the success of the previous generation of in-line filters. With various lengths, and diameters, these filters can be tailored to fit your specific needs. Available with quick connect fittings, as well as female pipe thread, the already simple and effective design can be installed in seconds.

Not sure what water filter to get? Need water filter replacement service? contact us.

SPECIFICATIONS

Flow Rate 0.5 gpm
Maximum Operating Pressure 125 psig
Operating Temperature 2 to 38 ºC - 35 to 100 ºF
Rated Capacity 1,500 gal/1 Year
Reduction Claim Chlorine, taste, color, and odor reduction
Flow Capacity 1,500 gal

Standards

ANSI (American National Standards Institute)
NSF (National Sanitation Foundation)

Performances:

ADDITIONAL INFOS

Cap and body are spin welded together producing a smooth, consistent seal without the use of glues or binders that can cause contamination. The result of these design and production techniques is a reliable filter that is fast and easy to install.

One of the primary uses of this product is as a system component. The benefit is derived from the fitting being molded directly into the filter cap, greatly reducing clearance. Shown here (right) is a reverse osmosis system with the traditional 12 in x 2.5 in filter configuration. Notice that all the filters are uniformly attached. This results in the most efficient use of available space and greater filtering performance in a smaller overall area.

The K-Series filter is available in 6 in, 8 in, 10 in, 12 in or 14 in lengths manufactured in 2 in or 2.5 in diameters. The true benefit is that systems can be designed to incorporate the various lengths and diameters - either all the same size or intermixed - to meet specific filtration needs.

Water filter heads sold separately.

Maintenance & installation

Note flow direction of filter.
For quick connect fittings, push scratch free tube end into the fitting until it bottoms. Threaded fittings must be wrapped with PTFE tape before installation. Install PTFE taped fittings and tighten firm. Use two wrenches to firmly tighten tubing.
Flush new cartridge with 5 gallons of water prior to use and check for leaks. If leaks occur, check tightness of tubing and fittings. If leaks persist, discontinue use and call your supporting dealer.Replace cartridge when rated capacity (1,500 gallons) is reached, or when flow becomes too slow.
Install in compliance with state and local laws and regulations.

Special Notices

The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your water.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.